Raid 1 Data Recovery Services Scottsdale Arizona

RAID 1 creates an exact copy (or mirror) of a set of data on two or more disks. This is useful when write performance is more important than minimizing the storage capacity used for redundancy. This is thought to be a foolproof method of data protection, but we commonly receive RAID 1 arrays that have failed due to:

The array can only be as big as the smallest member disk, however. A classic RAID 1 mirrored pair contains two disks, which increases reliability by a factor of two over a single disk, but it is possible to have many more than two copies. Since each member can be addressed independently if the other fails, reliability is a linear multiple of the number of members. To truly get the full redundancy benefits of RAID 1, independent disk controllers are recommended, one for each disk. Some refer to this practice as splitting or duplexing.

When reading, both disks can be accessed independently. Like RAID 0 the average seek time is reduced by half when randomly reading but because each disk has the exact same data the requested sectors can always be split evenly between the disks and the seek time remains low. The transfer rate would also be doubled. For three disks the seek time would be a third and the transfer rate would be tripled. The only limit is how many disks can be connected to the controller and its maximum transfer speed. Many older IDE RAID 1 cards read from one disk in the pair, so their read performance is that of a single disk. Some older RAID 1 implementations would also read both disks simultaneously and compare the data to catch errors. The error detection and correction on modern disks makes this less useful in environments requiring normal commercial availability. When writing, the array performs like a single disk as all mirrors must be written with the data.

RAID 1 has many administrative advantages. For instance, in some 365*24 environments, it is possible to "Split the Mirror": declare one disk as inactive, do a backup of that disk, and then "rebuild" the mirror. This requires that the application support recovery from the image of data on the disk at the point of the mirror split. This procedure is less critical in the presence of the "snapshot" feature of some filesystems, in which some space is reserved for changes, presenting a static point-in-time view of the filesystem. Alternatively, a set of disks can be kept in much the same way as traditional backup tapes are.